Contacts
Address
USA, Florida, Ocala, 34470-3642, 1617 NE 6th Ave
Director
Dan Schutt
Phones of enterprise
management
+1
When placing an order please inform the manager that you've learned the information on Allbiz! Thank you that you buy on Allbiz!
Internet
Site:
About enterprise
North American Products Corp, Company
Services - miscellaneous repair
In stock
For Cutting: Laminated & Raw MDG, Plywood, Particle Board
Designed for the high demands of panel saws. For pre-scoring the bottom sheet. Can also be used on sliding table saws. Also used table saws that utilize pre-scoring units.
Group: Cutting blade
In stock
For Cutting: Laminated & Raw MDF, Plywood, Particle Board
Designed for the high demands of panel saws. Used for cutting single and stacked sheets of laminated or raw MDF, Particleboard, Plywood, etc. Triple chip tooth design for high quality cuts and longevity.
Group: Cutting blade
In stock
For Cutting: Softwoods, Hardwoods
Designed for cross cutting and rip cuts in softwoods and hardwoods. Four alternate top bevel teeth with one flat raker tooth. Gullet on raker tooth of saw blade. Provides smooth cuts with minimum tearout.
Group: Sawing disks
In stock
For Cutting: Softwoods, Hardwoods
Designed for cross cutting softwoods and hardwoods where a superior quality cut is required. Alternate top bevel tooth design. Provides smooth cuts with minimum tearout on end grain applications even in thin material.
Group: Sawing disks
In stock
Saw Blades for Veneer
Laminated Board "Super Plus". Quality "super plus" for longer service life.
Group: Circular saws
In stock
An extensive selection of blades designed to cut brass, copper, aluminum and other non-ferrous metals.Excellent performance on sheets and extrusions.Heavier plates are used to withstand the rigors of non-ferrous metal cutting.All non-ferrous cutting should be aided by flood or spray...
Group: Circular saws
In stock
NAP GLADU's ASX Endmills have a coating designed specifically for the effective evacuation of Aluminum. These Endmills have unique geometry, highest possible feed rates and highest possible finish in the milling of Aluminum.
Group: Mills
In stock
Applications
An extremely accurate mounting system for use on those arbors that are not threaded.For use on moulders, tenon machines etc.
Technical Information
Type "BI" is threaded and has a knurled ring nut which allows the sleeve to be interchanged between various cutting tools.When under...
Group: Machine parts and mechanisms
In stock
Applications
An extremely accurate mounting system for use on those arbors that are not threaded.For use on moulders, tenon machines etc.
Technical Information
Type "A" is pressed into the cutting tool and retained by screws.When under pressure, only the inner sleeve expands towards the...
Group: Machine parts and mechanisms
In stock
For Cutting: Softwoods, Hardwoods
Designed for ripping both hard and softwoods. Can be used in both hand or automatic feed operations. Each tooth is 100% effective. Capable of faster feed rates over TCG and ATB styles. Can be modified for gang rip operations if desired.
Group: Saw blades